|
Short end mill, 4-flute, diameter 2.5mm, 8mm cutting length, total length 52mm, sized according to DIN 844 K standard, 6mm Weldon shank, powder metallurgical HSS-E, bright, 30° helix angle, 12° primary angle, suitable for angle milling, slot milling, ramp milling, for carbon, unalloyed carbon steels, brass or alloyed brass
Read more
|
End mills
C247 2.5 DORMER
Product number: 10650005776
Details
Technical details
| Sales unit | Piece |
|---|---|
| Length mm | 52 |
| Raw material code | HSS-E-PM |
| Standards | DIN 844 K |
| Shaft diameter mm | 6 |
| Number of cutting grooves | 4 |
| Shaft / Handle | DIN 1835B Weldon varsi |
| Flute helix angle | 30 |
| Lastuavan halkaisijan toleranssiluokka | k10 |
| Cutting diameter inch | 2,5 |
| Connection diameter mm | 6 |
| Suitability: Steels and cast steels | Best choice |
| Coating | Kirkas (pinnoittamaton) |
| Suitability: Stainless steels | Good choice |
| Suitability: Cast irons | Good choice |
| Suitability: Non-ferrous metals | Best choice |
| Suitability: Heat-resistant alloys | Best choice |