GC P5008 180 X 200 X 16

Conditions of use
Pressure: ≤ 400 bar
Temperature: -35 °C ... +110 °C
Speed: ≤0.5 m/s
Liquids: mineral oil-based hydraulic fluids
Gap >e< is selected according to the operating conditions using a nomogram.
Materials
The Parker material P5008 is a polyurethane-based elastomer, hardness 93 Shore A.
Compared to other polyurethanes, it has very good heat resistance, low residual compression and improved hydrolysis resistance.
Installation
Can be mounted in a closed groove.
Seals are available for grooves corresponding to ISO 5597/1.
Advantages
- Especially good wear resistance
- Highly resistant to pressure spikes and impact loads.
-High gap penetration resistance
-Low residual compression
-Reliable operation even in unpressurised conditions
-Suitable for tough conditions
-Easy to install
-In the middle of the profile of seals with a cross-section of > 10 mm, there is a ring-shaped support element which increases the stability of the seal.