Type M2
|
Conditions of use
Read more
Pressure: ≤350 bar Temperature: -40 °C ... +100 °C Speed: ≤0.5 m/s Liquids: Mineral oil-based hydraulic fluids, water-oil emulsions Gap >e< is selected according to the operating conditions using a nomogram Materials 7-part seal 1 - Bottom ring hard cloth-reinforced NBR rubber 2 - V-rings, three cloth-reinforced, NBR rubber 3 - V-rings, two made of NBR rubber 4 - Hat ring, cloth-reinforced rubber or plastic Installation Mounted in an open groove. The nominal size of the seal is the same as the size of the groove. The seal groove can be made adjustable with adapter rings. Adjustment margin least 5% of the groove length L. Adapter rings are removed as the seal becomes worn. Spring rings can be installed in the seal groove to adjust the pre-tightening of the seal. Usually used only with larger seals. Advantages - Thanks to the structure of the seal, it is very resistant to pressure shocks - Resistant to impurities in hydraulic fluid and scratches in abutments better than one-piece seals - Good sealing due to multiple sealing lips and a long contact surface - The seal can be cut off to help with the mounting |
Please login to view this content